Seal Spray Premium Neutral Silicone Elastic and Weatherproof Sealant - 10.1 oz. Tubes

Seal Spray Premium Neutral Silicone Elastic and Weatherproof Sealant - 10.1 oz. Tubes

Single-component neutral-curing silicone sealant with good processing properties, long shelf life and a wide application area. Insulates and seals in both indoor and outdoor conditions. Adheres to most building materials such as stone, metal, wood materials, glass and plastic surfaces. Suitable for slightly alkaline metal surfaces and porous surfaces. Mould, UV, moisture and weather resistant. Low odor.

Field of applications : Insulation and sealing of connections in general construction and repair works. Also suitable on surfaces where acid-curing silicone cannot be used. All finishing, insulation and ventilation works both indoor and outdoor. Suitable for wet and dry rooms.

Product has been tested and is classified accordingly:

Sealant for facade for interior and exterior application, intended for use in cold climate. EN 15651-1:2012: Type F-INT-EXT-CC: CLASS 12,5E

Sealant used for sanitary applications. EN 15651-3:2012: Type S: CLASS S3

Application conditions : Application temperature between +5 °C and +40 °C. The application temperature of the sealant must be +20 °C - +25 °C. The application at temperatures lower than +5 °C, can only be carried out when connected surfaces are free of condensation, snow and ice. The surfaces must be clean from dust, loose particles and oil. Not suitable for sealing aquariums and for under-water applications. Not paintable.

Application instructions : The surfaces must be clean from dust, loose particles and oil.

Cut off the threaded end of the cartridge and screw on the application nozzle for directing sealant. Cut the threaded end in a way where a suitable opening for application is produced. Place the cartridge together with the applicator in the gun and fill the installation nozzle with sealant, by repeatedly pressing the gun trigger.

Apply sealant in the joint by repeatedly and evenly pressing on gun trigger and smoothly dragging the nozzle along the joint. After application, smooth the surface with a rubber silicone scraper and remove excess material.

Ensure adequate ventilation in all joint locations. During the curing process, make sure that no impurities can settle on the surface and that the joint surface is not affected by mechanical load.

Cleaning : Clean uncured sealant with solvents like white spirit, acetone. Cured sealant can be removed mechanically.

Storage conditions : Guaranteed storage time 18 months starting from the date of manufacture if stored in a closed original package in a dry place between +5 °C and +30 °C.

Safety regulations: Ensure sufficient ventilation during application. Keep out of the reach of children. Avoid contact with skin and eyes. In case of contact with eyes, rinse immediately with water and seek medical advice. Detailed safety information is available on safety data sheet (SDS).